Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top dead point (VMT) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   - 3.13. Oil pallet
      3.13.1.2. Installation
      - 3.13.2. Engine 1MZ-FE
         3.13.2.2. Installation
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



3.13.2. Engine 1MZ-FE

3.13.2.1. Removal
GENERAL INFORMATION
Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.

Arrangement of bolts of fastening of aluminum section of the oil pallet to the block of cylinders

PERFORMANCE ORDER
1. Uncover a maslozalivny mouth.
2. Remove a weight wire from the accumulator.
3. Lift a forward part of the car and fix on supports.
4. Remove an engine mudguard.
5. Merge engine oil and unscrew the oil filter.
6. Remove a reception exhaust pipe.
7. Unscrew two bolts and remove a protective casing of a case of a flywheel. 8. Unscrew two bolts, fixing aluminum section of the oil pallet to a transmission.
9. Unscrew 10 bolts and two nuts, fixing steel section of the oil pallet, and remove it.
10. Remove a pipe of a maslopriyemnik with the mesh filter.
11. Unscrew 17 bolts, fixing aluminum section of the oil receiver to the block of cylinders and remove it (see fig. An arrangement of bolts of fastening of aluminum section of the oil pallet to the block of cylinders).