Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top dead point (VMT) of the piston of the first cylinder
   - 3.5. Cover of a head of the block of cylinders
      3.5.1.2. Installation
      + 3.5.2. Engine 1MZ-FE
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

3.5. Cover of a head of the block of cylinders

3.5.1. Engine 3VZ-FE

3.5.1.1. Removal

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.
Preventions At existence in a code radio receiver against theft before a detachment of the accumulator check that you have connection codes. On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.
2. If the head cover from a back head of the block of cylinders acts in film, remove the back thermofilter, a casing of the air filter, a throttle and an air inlet.
	3. If the head cover from a forward head of the block of cylinders acts in film (about a radiator), remove high-voltage wires from spark plugs.
	4. Separate a forward plait of wires and disconnect electric sockets from the following elements: а) three left fuel nozzles, б) sensor of pressure of oil, в) conditioner compressor. г) generator, д) the sensor of temperature of cooling liquid.
	5. Disconnect a back plait of wires and disconnect электричес cues sockets from the following elements: а) three right fuel nozzles, б) the sensor of the index of temperature of cooling liquid, в) sensor of oxygen, г) pump of the amplifier of a steering.
	6. Unscrew nuts and uncover heads of the block of cylinders.