Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top dead point (VMT) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   - 3.14. Oil pump
      3.14.2. Check
      3.14.3. Installation
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



3.14.3. Installation

PERFORMANCE ORDER
1. Replace a sealing ring in the case of the oil pump.
2. Establish external and internal rotors in the case of the oil pump, thus combine adjusting labels on rotors of the oil pump.
3. Put on an interfaced surface of a cover of the oil pump a thin layer of vaseline, establish a cover on the case of the oil pump and screw screws.
4. Grease details of a safety valve with pure engine oil and establish them in the case of the oil pump.
5. Clear a surface of the case of the oil pump, interfacing my to the block of cylinders of the engine from oil.
Put on an interfaced surface of the case of the oil pump a hermetic layer in diameter of 2-3 mm.
Establish sealing laying of round section in a flute of the case of the oil pump.
6. Combine a groove on an internal rotor of the oil pump with a shponka of a cranked shaft and establish the oil pump on the block of cylinders of the engine.
7. Fix the oil pump bolts, tightening them crosswise.
8. Establish a pipe of a maslopriyemnik with new laying and fix bolts.
9. Further installation is made in sequence, return to removal. Add engine oil in the engine.