Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   - 2.6. Final collector
      2.6.1. Removal
      2.6.2. Installation
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   + 2.10. Camshaft and pushers
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.6.1. Removal
GENERAL INFORMATION
Preventions

At existence in a code radio receiver against theft, before an accumulator detachment, check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect a wire of the sensor of oxygen and its fastening. If replacement of a final collector is required, remove the oxygen sensor.
3. Unscrew bolts and remove the top thermofilter from a final collector.
4. Grease bolts and nuts of fastening of a final collector with oil, fuel or brake liquid.
5. Disconnect the catalytic converter from a final collector.
6. Remove an arm of support of a final collector (some models have two arms) and the bottom thermofilter.
7. Unscrew nuts of fastening and remove a collector together with laying.