Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   - 3.4. Top dead point (VMT) of the piston of the first cylinder
      3.4.1. Engine 3VZ-FE
      3.4.2. Engine 1MZ-FE
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   + 3.8. Gear belt and pulleys
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

3.4.1. Engine 3VZ-FE

GENERAL INFORMATION

Arrangement of high-voltage wires on a cover of the distributor of ignition

PERFORMANCE ORDER

1. Note position of the plug of the first cylinder on a distributor cover. If the label is absent, determine it by the high-voltage wire going from a candle of the first cylinder.
2. Using chalk or a felt-tip pen, put on the distributor case a label located under contact of the first cylinder.
3. Uncover the distributor and move it aside.
	4. Turn a cranked shaft of the engine while the label on a pulley of a cranked shaft will not be combined with figure 0 on a plate of installation of the mechanism of the gazoraspredeleniye, located on the forward party of the engine.
5. Check the provision of a rotor of the distributor which should be directed on a label put on the case of the distributor. If the rotor of the distributor is sent to the opposite side, the piston of the first cylinder is in the top dead point in an exhaust step.
6. For installation of the piston of the first cylinder in VMT in a step of compression turn a cranked shaft on 360 ° clockwise. Thus the rotor of the distributor should be combined with a label.