Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
- 3. Six-cylinder V6 engines
   3.2. General information
   3.3. The repair which is not demanding removal of the engine
   + 3.4. Top dead point (VMT) of the piston of the first cylinder
   + 3.5. Cover of a head of the block of cylinders
   + 3.6. Inlet collector
   3.7. Final collector
   - 3.8. Gear belt and pulleys
      3.8.2. Check
      3.8.3. Installation
   3.9. Replacement of a forward sealing ring of a cranked shaft
   3.10. Replacement of sealing rings of camshafts
   + 3.11. Camshafts and pushers
   + 3.12. Head of the block of cylinders
   + 3.13. Oil pallet
   + 3.14. Oil pump
   3.15. Drive flywheel / plate
   3.16. Replacement of a back sealing ring of a cranked shaft
   3.17. Suspension bracket of the power unit
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



3.8.2. Check
GENERAL INFORMATION
Preventions

Do not overwind and do not bend a gear belt. Exclude hit on a gear belt of the oil, cooling liquid or fuel.

If there was a rupture of a gear belt on the working engine, it is possible that there was an impact of pistons about the valve therefore the valve can be погнуты. Check gaps of valves. On pognuty valves klapanny gaps will be much more demanded.

PERFORMANCE ORDER

1. Remove single pulleys and check a condition them подшипни ков. Check a condition of a spring and check a spring dyne in a free condition.

2. If there was a vykrashivaniye of teeths of a gear belt, probably, the ignition distributor, the water pump, the oil pump or a camshaft are jammed.

3. If there is a considerable wear or stratification on an external surface of a gear belt, check a condition of a racetrack of single pulleys.
4. If there is a wear or damage only on one party of a belt, check directing a gear belt and alignment of pulleys of a gear belt.
5. Check the mechanism of a tension of a gear belt on existence of leakages of liquid.
6. Pressing a pusher of the mechanism of a tension, check tightness of the mechanism of a tension and lack of a course of a pusher. If the pusher enters into the tension mechanism, replace the tension mechanism. 7. Check a pusher vystupaniye from the case of the mechanism of a tension. If the vystupaniye of a pusher differs from demanded, replace the tension mechanism.