Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   - 6.4. Check of the fuel pump
      6.4.2. Check of the pressure created by the fuel pump
      6.4.3. Check of a regulator of pressure of fuel
      + 6.4.4. Check of the relay of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   + 6.13. Check and replacement of elements of system of injection of EFI fuel
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



6.4.2. Check of the pressure created by the fuel pump

GENERAL INFORMATION

Giving of tension of the accumulator by additional wires for check of operability of the fuel pump on models with V6 engines 1MZ-FE with 1994г.

The adapters used for connection of a manometer to the top part of the fuel filter

The pressure created by the fuel pump in the fuel highway, should make at least 3,3 bar.
PERFORMANCE ORDER
1. Uncover a toplivozalivny mouth.
2. Check that tension of the storage battery corresponds to norm.
3. Remove pressure in the fuel highway.
4. Using adapters, connect a manometer to the top part of the fuel filter (see fig. The adapters used for connection of a manometer to the top part of the fuel filter).
5. Establish the gear shifting lever in neutral situation and tighten the hand brake.
6. An additional wire connect contacts +В and Fр on the control socket (see fig. Electric circuit of a food of the fuel pump).
On models with the engine 1MZ-FE it is necessary to submit additional wires tension from the accumulator to the fuel pump (see fig. Giving of tension of the accumulator by additional wires for check of operability of the fuel pump on models with V6 engines 1MZ-FE with 1994г.).
7. Include ignition, but do not start the engine. By indications of a manometer determine the pressure created by the fuel pump in the fuel highway. If pressure too high, check a condition of the return топливопровода. If топливопровод in a normal state, replace a pressure regulator. If pressure too low, replace a pressure regulator. If pressure does not increase, check a condition of a submitting fuel tube, a fuel tank and the fuel filter.
8. Remove closing wire on the control socket.
9. Start the engine.
а) measure pressure of fuel on turns of idling,
б) check vacuum in a hose and a regulator of pressure of fuel.
10. Switch off the engine and in 5 minutes check pressure of fuel which should be not less than 1,2 bar.
11. Remove a manometer for measurement of pressure of fuel.