Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      - 2.10.1.1. A camshaft operating final valves
         2.10.1.2. A camshaft operating inlet valves
      2.10.2. Check
      + 2.10.3. Installation
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.10.1.1. A camshaft operating final valves

PERFORMANCE ORDER

1. Turn camshafts in such situation that the adjusting pulley of the camshaft operating final valves was on 10-45 ° to the left from the vertical line.

2. Screw in an additional bolt of M in 6 x 1 length about 20 mm in a gear wheel of the camshaft operating выпускны ми valves.
3. Unscrew a bolt of fastening of a back cover of the bearing of the camshaft operating final valve ми, and uncover.
4. Unscrew bolts of fastening of covers of bearings distribute a telny shaft No. 1, 2 and 4 on a turn half for each pass before complete unscrewing of bolts. Remove the 1st, 2nd and 4th cover of bearings of a camshaft.
5. Gradually and consistently unscrew bolts of fastening of a cover of the No. bearing 3 camshafts and uncover.
6. Remove a camshaft from a head of the block of cylinders.