Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      + 2.10.1.1. A camshaft operating final valves
      2.10.2. Check
      + 2.10.3. Installation
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.10.2. Check

PERFORMANCE ORDER
1. Measure distance between the ends of a spring ring of fastening of a gear wheel on distributive to a shaft.
2. Mark and take pushers together with регулировоч ny plates.
3. Examine each pusher on existence of wear and scratches.
4. Check working surfaces of bearings the distributor of ny shaft and contours of cams of camshafts on wear. In the presence of any wear replace a camshaft.

5. Using a micrometer, measure height of cams of camshafts...
6.... and diameters of necks of bearings of camshafts.
7. Check a working gap of bearings of a camshaft as follows.
7a. Clear covers of bearings and a camshaft neck.
7б. Establish a camshaft in a head of the block of cylinders, thus do not establish pushers and do not grease a camshaft.
7в. Cut off a slice of a plastic core of Plastigage (it should be slightly shorter, than width of the bearing) and establish on a camshaft neck.
7г. Establish a bearing cover, thus the arrow on a cover of the bearing should be directed to a forward part of the engine.
7д. Tighten bolts of fastening of a cover of the bearing of a camshaft the demanded moment and in stages.
Prevention

In the course of measurement of a working gap by the Plastigage method do not rotate a camshaft.


7е. Unscrew bolts and uncover the camshaft bearing.
7ж. To the deformed plastic core put a large-scale ruler. Comparing width of the deformed plastic core with control width on a large-scale ruler, define size of a working gap.

7з. In end carefully clear Plastigage-material traces from bearings and a camshaft.

8. Temporarily establish camshafts without толкате pour into a head of the block of cylinders and measure люфт between teeths of gear wheels of camshafts.