Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
- 2. Engine
   2.2. Operations on engine repair on the car
   2.3. Top dead point of the first cylinder
   + 2.4. Cover of a head of the block of cylinders
   + 2.5. Inlet collector
   + 2.6. Final collector
   + 2.7. Gear belt and pulleys
   2.8. Replacement of a forward sealing ring of a cranked shaft
   2.9. Replacement of a sealing ring of a camshaft
   - 2.10. Camshaft and pushers
      + 2.10.1.1. A camshaft operating final valves
      2.10.2. Check
      - 2.10.3. Installation
         2.10.3.2. A camshaft operating final valves
   + 2.11. Head of the block of cylinders
   + 2.12. Oil pallet
   + 2.13. Oil pump
   + 2.14. Drive flywheel / plate
   2.15. Replacement of a back sealing ring of a cranked shaft
   + 2.16. Suspension bracket of the power unit
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



2.10.3.2. A camshaft operating final valves
PERFORMANCE ORDER
1. Grease pushers with pure engine oil and establish them in a head of the block of cylinders together with adjusting laying.
2. Grease with pure engine oil cams and necks подшипни ков a camshaft.
3. Turn a camshaft operating впускны ми valves in such situation that the adjusting pin was established on 10 ° to the left from the vertical line.
4. Establish a camshaft operating выпускны ми valves in a head of the block of cylinders so that of a label on gear wheels of shaft were combined.
5. Establish covers of bearings of a camshaft according to identification labels, thus shooters on covers should be directed to a forward part of the engine.
6. Gradually and consistently in an order shown in drawing, screw up bolts of fastening of covers of bearings of a camshaft.
7. Establish a pulley of a gear belt on a camshaft operating inlet valves and tighten it the demanded moment, thus hold a camshaft from a provorachivaniye the second wrench.
8. Establish a gear belt.
9. Further installation is made in sequence, return to removal.