Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   - 6.13. Check and replacement of elements of system of injection of EFI fuel
      6.13.1.2. Replacement
      + 6.13.2. Sensor of provision of a butterfly valve (TPS)
      6.13.3. Regulator of pressure of fuel
      + 6.13.4. Nozzle of cold start of the engine (V6 engine 3VZ-FE)
      + 6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
      + 6.13.6. Control air valve (IAC)
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



6.13.3. Regulator of pressure of fuel

6.13.3.1. Replacement

GENERAL INFORMATION

Arrangement of a sealing ring of round section at installation of a regulator of pressure upon the fuel highway

PERFORMANCE ORDER
1. Remove pressure in the fuel highway.
2. Remove a weight wire from the accumulator.

Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


3. Disconnect a vacuum hose from a regulator of pressure of fuel.
4. Weaken a collar and remove a returnable fuel hose from a pressure regulator.
5. Unscrew bolts of fastening of a regulator of pressure and remove a pressure regulator from the fuel highway.
6. Using a sealing ring of round section, establish a regulator of pressure upon the fuel highway (see fig. An arrangement of a sealing ring of round section at installation of a regulator of pressure upon the fuel highway).
7. Further installation is made in sequence, return to removal.