| 1. Remove a head of the block of cylinders, the oil pallet and a pipe of a maslopriyemnik. |
| 2. On engines 5S-FE remove balance weight assembly. |
|
|
3. If there is a deposit in the top part of the cylinder, remove it with a scraper from a soft material or the special adaptation. Step existence in the top part of the cylinder testifies to excessive wear of the cylinder and need of boring of the cylinder of the engine. |
| 4. Overturn the engine cranked shaft up. |
|
|
| 5. Check a lateral gap of all bottom heads of a rod. |
6. Using a hammer and a center punch or paint, note the provision of a cover of the bottom head of a rod and cylinder number. |
| 7. Unscrew nuts of fastening of a cover of the bottom head of a rod of the first cylinder. Remove the bottom cover of a rod. |
|
|
8. For protection of necks of a cranked shaft and sleeves of cylinders against damage establish on hairpins of fastening of the bottom head of a rod pieces of a rubber tube. |
| 9. Using the hammer handle, вытолкните the piston up the block of cylinders also take it from the block of cylinders. |
|
10. On the bottom head of a rod establish a cover of a rod and screw nuts that will allow to keep them in a set and not to mix in places. |