Toyota Camry

1992-1997 of release

Repair and car operation


Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Major maintenance of engines
   4.2. General information
   4.3. Compression check
   4.4. Recommendations about engine removal
   + 4.5. Removal and engine installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control люфта balance weight assemblies (engine 5S-FE)
   4.17. Engine balance of assembly at major maintenance
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Engine start after major maintenance
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



4.23. Engine start after major maintenance
PERFORMANCE ORDER

1. On the engine established in a motor compartment of the car, check levels of engine oil and cooling liquid. Check that all earlier removed wires and hoses установле ны on the places.

2. Disconnect the electric socket from the block of ignition and remove the relay of the fuel pump. Turn the engine a starter until the control lamp of pressure of oil will not go out, then connect the electric socket to the block of ignition and establish the relay of the fuel pump.

3. Start the engine. Start of the engine can be more long, than usually because of shutdown of fuel system.
4. At operation of the engine idling check existence of leakages of the fuel, cooling liquid and oil. At this stage of operation of the engine the smell and a smoke from warm parts of the engine can be observed at burning out of the oil which has got on the engine at assembly.
5. The engine should idle until cooling liquid will not heat up that will be felt through the top hose of a radiator. Then switch off the engine. After cooling of the engine check level of oil and cooling liquid.
6. At installation in the engine of new pistons, piston rings or bearings of a cranked shaft it is necessary to make an engine running in during run of the first 800 km. Not эксплуа тируйте the engine with completely open butterfly valve or under big loading at low frequency of rotation of the engine. It is recommended to replace oil and the oil filter at the end of the running in period.