Repair and Toyota Camry car operation - 4.7. Dismantling of a head of the block of cylinders//Kamri's Toyota of 1992-1997 / frndl.ru

Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Major maintenance of engines
   4.2. General information
   4.3. Compression check
   4.4. Recommendations about engine removal
   + 4.5. Removal and engine installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control люфта balance weight assemblies (engine 5S-FE)
   4.17. Engine balance of assembly at major maintenance
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Engine start after major maintenance
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



4.7. Dismantling of a head of the block of cylinders

PERFORMANCE ORDER
1. When dismantling a head of the block of cylinders note details for their installation on the places.
2. Before removal of valves prepare a place for storage of the corresponding details. 3. Using the adaptation for compression of a spring of the valve, compress each spring and remove crackers from a valve end face. Remove the adaptation for compression of a spring and take a plate of a spring and a spring. Flat-nose pliers, being careful, take a maslootrazhatelny cap from a valve rod.
4. When the spring of the valve is removed, and the cup of a spring does not remove ся from crackers, it is necessary to strike with a hammer through wooden whetstone on a spring cup that will lead to release of crackers.
5. Take the valve via the combustion chamber. Each valve store in a separate plastic bag together with a plate of a spring, a spring, a nest of a spring and crackers for their further installation on the places.
6. Similarly remove the others of the valve from a head of the block of cylinders.