Toyota Camry

1992-1997 of release

Repair and car operation

Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Major maintenance of engines
   4.2. General information
   4.3. Compression check
   4.4. Recommendations about engine removal
   + 4.5. Removal and engine installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control люфта balance weight assemblies (engine 5S-FE)
   4.17. Engine balance of assembly at major maintenance
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Engine start after major maintenance
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment

4.13. Pistons and rods

4.13.1. Check

PERFORMANCE ORDER

1. Before check of pistons with rods remove from pistons piston rings and carefully clear pistons.
2. For removal of piston rings from pistons unclench a piston ring and insert under a ring evenly on a circle two or three old edges щупа and on them shift a ring from the piston. Be careful, do not scratch the piston the ring ends. Rings very fragile also can burst, if them to unclench very strongly. Working edges of piston rings very sharp, therefore address with them very carefully not to be cut. Hold each set of rings together with pistons for repeated installation them on the places.
3. Clear all traces of a deposit from the top part of the piston.
	4. Remove a deposit from flutes under piston rings in the piston, using an old piston ring.
5. After removal of a raid clear the piston with a rod соответ stvuyushchy solvent and wipe dry.
6. Carefully examine each piston on existence of cracks round a skirt and openings under a piston finger.
7. Check wear on a piston skirt, an opening in a piston head, and also burned in the top part of the piston.
8. Traces of dot corrosion on the piston specify that cooling liquid got to the chamber of combustion. It is necessary to find the reason of hit of cooling liquid in the chamber of combustion and to eliminate it.
	9. Measure diameter of the piston.
10. Define a piston gap in the cylinder for what from diameter of the cylinder take away diameter of the piston and divide into two.
	11. Check a gap of a piston ring in a piston flute.