Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
+ 4. Major maintenance of engines
+ 5. Cooling and heating
- 6. Fuel system
   6.2. General information
   6.3. Pressure removal in fuel system
   + 6.4. Check of the fuel pump
   6.5. Fuel pump
   + 6.6. Fuel level sensor
   6.7. Fuel tank
   6.8. Air filter
   + 6.9. Accelerator cable
   6.10. Electronic system of injection of EFL fuel
   + 6.11. Fuel system
   6.12. Check of system of injection of fuel
   - 6.13. Check and replacement of elements of system of injection of EFI fuel
      6.13.1.2. Replacement
      + 6.13.2. Sensor of provision of a butterfly valve (TPS)
      6.13.3. Regulator of pressure of fuel
      - 6.13.4. Nozzle of cold start of the engine (V6 engine 3VZ-FE)
         6.13.4.2. Removal
      + 6.13.5. Timer of a nozzle of cold start of the engine of the V6 model 3VZ-FE
      + 6.13.6. Control air valve (IAC)
   6.14. Fuel highway and fuel nozzles
   + 6.15. Valve of a mode of idling of central air of air
   6.16. Air inlet chamber (only V6 engines)
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment


flashcards

6.13.4.2. Removal

GENERAL INFORMATION

Fuel nozzle of cold start of the engine

1–electric socket;
2–топливопровод;
3–connecting bolt;
4–laying;
5–fuel nozzle of cold start;
6–laying


PERFORMANCE ORDER
1. Remove pressure in fuel system.
2. Remove a weight wire from the accumulator.
Preventions

At existence in a code radio receiver against theft, before a detachment of the accumulator check that you have connection codes.

On models since 1993 the system of an airbag of safety is disconnected, if the accumulator is disconnected for long term. If a control lamp of a safety cushion it lights up and necessary to burn after repeated connection of the accumulator, it is necessary to address in a specialized workshop for restoration of operability of system.


3. Disconnect the electric socket from a fuel nozzle of cold start.
4. Unscrew a bolt, a fixing hose of supply of fuel to a fuel nozzle of cold start.
5. Unscrew two nuts and remove a fuel nozzle of cold start from the engine together with laying (see fig. Fuel nozzle of cold start of the engine).
6. Installation is made in sequence, return to removal.