Toyota Camry
1992-1997 of release
Repair and car operation
Kamri's Toyota
+
General data
+
1. Maintenance
+
2. Engine
+
3. Six-cylinder V6 engines
-
4. Major maintenance of engines
4.2. General information
4.3. Compression check
4.4. Recommendations about engine removal
+
4.5. Removal and engine installation
4.6. Sequence of dismantling of the engine
4.7. Dismantling of a head of the block of cylinders
+
4.8. Cleaning and survey of a head of the block of cylinders
4.9. Assembly of a head of the block of cylinders
4.10. Removal of pistons with rods
4.11. Removal of a cranked shaft
+
4.12. Block of cylinders of the engine
4.13. Pistons and rods
4.14. Cranked shaft
-
4.15. Survey and choice of radical and shatunny bearings
-
4.15.2. Choice
4.15.2.1. Radical bearings
4.15.2.2. Shatunnye bearings
4.15.2.3. All bearings
4.16. Control люфта balance weight assemblies (engine 5S-FE)
4.17. Engine balance of assembly at major maintenance
4.18. Installation of piston rings
+
4.19. Installation of a cranked shaft and check of working gaps of bearings
4.20. Installation of a back sealing ring of a cranked shaft
4.21. Installation of pistons and rods, check of working gaps of bearings
4.22. Installation of assembly of the balance weight (engine 5S-FE)
4.23. Engine start after major maintenance
+
5. Cooling and heating
+
6. Fuel system
+
7. Ignition system
+
8. Toxicity fall
+
9. Transmission
+
10. Automatic transmission
+
11. Coupling and power shafts
+
12. Brake system
+
13. Suspension bracket
+
14. Body
+
15. Electric equipment
4.15.2.2. Shatunnye bearings
GENERAL INFORMATION
Drawing of labels of identification on a cover and the bottom head of a rod
If the standard cranked shaft is used, it is necessary to establish the shatunny bearing which number is beaten out on a rod head.