Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Major maintenance of engines
   4.2. General information
   4.3. Compression check
   4.4. Recommendations about engine removal
   + 4.5. Removal and engine installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   - 4.12. Block of cylinders of the engine
      4.12.2. Check
      4.12.3. Honingovaniye of cylinders
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control люфта balance weight assemblies (engine 5S-FE)
   4.17. Engine balance of assembly at major maintenance
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Engine start after major maintenance
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment
вакансии - Москва



4.12.3. Honingovaniye of cylinders

GENERAL INFORMATION

Honingovaniye of walls of cylinders creates optimum conditions for work of piston rings. The greatest distribution was received by the honingovalny tool with podpruzhinenny whetstones. The honingovalny tool in the form of a round wire brush is also widely applied. Besides, carrying out a honingovaniye will need a kerosene quantity, rags and an electric sverlilka.

PERFORMANCE ORDER
1. Establish to the place of a cover of radical bearings and tighten bolts of fastening them the demanded moment.
2. Fix on an electric sverlilka the honingovalny tool and insert it into the cylinder.
3. Grease with a thin layer of kerosene of a wall of the cylinder, include an electric sverlilka and move the honingovalny tool up and down to that time while on walls the correct being crossed drawing is not formed. Ideally lines should be crossed at an angle 60 °. Watch that in the course of a honingovaniye of a wall were moistened with a thin layer of kerosene.
4. Do not take the honingovalny tool from the block of cylinders at the included electric sverlilka. Moreover, make some courses of the honingovalny tool at the switched-off sverlilka and only after that take it from the block of cylinders.
5. Similarly отхонингуйте other cylinders.
6. Carefully wash out the block of cylinders from the remains of the abrasive tool.
7. Dry up the block of cylinders and grease surfaces with a thin butter layer.