Toyota Camry

1992-1997 of release

Repair and car operation



Kamri's Toyota
+ General data
+ 1. Maintenance
+ 2. Engine
+ 3. Six-cylinder V6 engines
- 4. Major maintenance of engines
   4.2. General information
   4.3. Compression check
   4.4. Recommendations about engine removal
   - 4.5. Removal and engine installation
      4.5.1. Removal
      4.5.2. Installation
   4.6. Sequence of dismantling of the engine
   4.7. Dismantling of a head of the block of cylinders
   + 4.8. Cleaning and survey of a head of the block of cylinders
   4.9. Assembly of a head of the block of cylinders
   4.10. Removal of pistons with rods
   4.11. Removal of a cranked shaft
   + 4.12. Block of cylinders of the engine
   4.13. Pistons and rods
   4.14. Cranked shaft
   + 4.15. Survey and choice of radical and shatunny bearings
   4.16. Control люфта balance weight assemblies (engine 5S-FE)
   4.17. Engine balance of assembly at major maintenance
   4.18. Installation of piston rings
   + 4.19. Installation of a cranked shaft and check of working gaps of bearings
   4.20. Installation of a back sealing ring of a cranked shaft
   4.21. Installation of pistons and rods, check of working gaps of bearings
   4.22. Installation of assembly of the balance weight (engine 5S-FE)
   4.23. Engine start after major maintenance
+ 5. Cooling and heating
+ 6. Fuel system
+ 7. Ignition system
+ 8. Toxicity fall
+ 9. Transmission
+ 10. Automatic transmission
+ 11. Coupling and power shafts
+ 12. Brake system
+ 13. Suspension bracket
+ 14. Body
+ 15. Electric equipment



4.5.2. Installation

GENERAL INFORMATION

Prevention

Do not use bolts for transmission alignment concerning the engine. It can lead to splitting or damage of large knots of the engine.


PERFORMANCE ORDER

1. Check a condition of support of engine mounts and a transmission. If they are worn-out or damaged, replace them.

2. On models with a mechanical transmission check a coupling condition. On models with an automatic transmission check a condition of a sealing ring and the plug.

3. On models with a mechanical transmission grease with a small amount of high-temperature greasing the bearing in an end face of a cranked shaft. On models with an automatic transmission grease with high-temperature greasing a nasal part of the converter.
4. Being careful, establish a transmission on the engine.
5. Bolts fix a transmission to the engine, having tightened them the demanded moment.
6. Using the load-lifting mechanism, lower the engine together with a transmission in a motor compartment. At installation of the power unit, if necessary, incline and turn it so that it was established into place, without having caused harm.
7. Establish bolts of fastening of a suspension bracket of the power unit and tighten them the demanded moment.
8. Establish earlier removed details and restore everything connect a niya in sequence, return to removal.
9. Fill in in the engine cooling liquid, engine oil and, if necessary, add oil in a tank of the amplifier of a steering.
10. Start the engine and check its work. Switch off the engine and check level of all liquids.